Camel Precision Co., LTd. Logo
Banner

main icon  Hydraulic Gear Pumps - EGC  

Home > Products > Pump > External Gear Pump > EGC Hydraulic Gear Pumps

EGC Hydraulic Gear Pumps

External Gear Pump - EGC

  1. High volume, high efficiency and high pressure.
  2. Special gear design, noise is very low.
  3. Compace body and space saving.
  4. Aluminum alloy, gravity casting body.
  5. Light weight and sturdiness.
  6. Standard SAE two ports flange.

ModelTheoretical
Displacement		Operating Pressure Shaft Speed
Range (rpm)		Dimension
(mm)		In/Outlet Dimension
(mm)
continuous
Max. PressurePeak Pressure
(c.c./rev.)(kgf/cm²)(kgf/cm²)(kgf/cm²)Max.Min.ABInletOutlet
EGC-19 19 230 250 280 3600 600 66 132 25 18.5
EGC-22 22 210 230 250 3600 600 68 136 25 18.5
EGC-26 26 210 230 250 3600 600 70.5 141 25 18.5
EGC-32 32 190 210 230 3600 600 75 150 25 18.5

Unit: mm

Dimension

  1. Pump must be located with driving shaft coaxial to power take off. The drive system must not impose axial or radial load to pump shaft.
  2. Hydraulic fluid
    Use a mineral based hydraulic oil with additive to resist oxidatioon, Corrosion and foaming or an engine oil.
    Recommend viscosity
    Mineral oil 3÷5 E 50°C --- Enging oil SAE 10,20,30 depending on environment temperature.
    Operating Temperature range: 15 - 70°C
    Viscosity: 1.45 E
    Maximum viscosity during starting: 200 °E
  3. Filtration
    Before filling the system, ensure that circuit is perfectly clean. Filter must be adequate in capacity and preferably with blockage indicators. Filter must be changed according to operating instruction. Recommended filtering: Suction side 90 mesh, Return side 25 medium porosity.
  4. Piping Instruction
    Avoid sharp bends and restrictions on the circuit.
    Maximum inlet depression: 250mm/Hg
    Maximum oil speed suction side: 0.5÷1.5 Mt/sec
    Maximum oil speed outlet side: 3÷8 Mt/sec
    Maximum oil speed return side: 2÷3 Mt/sec

  1. No radial or axial forces may be permitted to act on the pump drive shaft.
  2. The alignment of motor and pump must be adjusted precisely.
  3. Always use a coupling which will permit compensation for any shaft displacement.
  4. When mounting the coupling, avoid applying axial force, i.e. never attempt to press or knock into place using a hammer or similar instrument.

  1. Every pumps supplied by Camel have been passed by performance and function testing.
    Any attempts to modify the pump is not allowed and will not keep the warranty.
    Maintenance must be performed by the manufacturer or by authorized dealers. No warranty can be accepted for unauthorized repairs.
  2. Repairs may only be performed by the manufacturer or by authorized dealers and branches. No warranty can be accepted for unauthorized repairs.